Marantz PM-14S1 Manual de usuario Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
24
ENGLISH
MM/MC cartridge select
Therearetwotypes--MM(MovingMagnet)andMC(Moving
Coil)--ofcartridgesforturntable.
Astheoutputlevelsforthesetwotypesofcartridgesdier,
thesettingofthephonoequalizerthatismountedinthisunit
mustbeswitchedaccordingtothetypeofcartridgeforyour
turntable.Forswitching,usethePHONOMCbuttononthis
unit.
Speaker impedance
ThisisanACresistancevalue,indicatedinΩ(Ohms).Greater
powercanbeobtainedwhenthisvalueissmaller.
Protection circuit
This is a function to prevent damage to devices within the
power supply when an abnormality such as an overload,
excessvoltageoccursorovertemperatureforanyreason.
Ifamalfunctionoccursinthisunit,thepowerindicatorblinks
redandtheunitswitchestostandbymode.
Appendix
Explanation terms
Thisunitisequippedwitha protectioncircuitto protectthe
ampliercircuitsandspeakersystemfromdamage.
If the protection circuit is activated, the sound is instantly
muted.
Inthiscase,themessage“PROTECT”ashesonthedisplay
panel,andtheSTANDBYindicatoralsoashes.
Todeactivatetheprotectioncircuit,turntheunitothenback
onagainafterabout1minuteormore.
At power on
Forabout8secondsafterthepoweristurnedon,theprotection
circuit is activated, muting the sound to give the amplier
circuitstimetostabilize.Oncetheampliercircuitsstabilize,
theprotectioncircuitisreleased,andaudioisenabled.
In the event of overcurrent
Theprotectioncircuitisactivatedifcurrentexceedingacertain
levelisdetected,whichcanhappenifexcessivesignalowis
inputtotheamplieroriftheunitisconnectedtoaspeaker
system of less than 4 Ω/ohms impedance. The protection
circuitisalsoactivatedifaspeakercableshorts.
Insuchcases,themessage“PROTECT”ashesonthedisplay,
andthevolumeisautomaticallyreduced.Afterapproximately
8 seconds, the protection circuit is released. Therefore, the
volumeneedsreadjustingtocontinuenormaluse.
If the overcurrent continues, the amplier shuts itself OFF,
andtheSTANDBYindicatorashes.
Todeactivatetheprotectioncircuit,turntheunitothenback
onagainafterabout1minuteormore.
If excessive ultrabass signals are input
Theprotectioncircuitisalsoactivatedifultrabasssignalsare
input. In such a case, the STANDBY indicator ashes, and
the volume is automatically reduced. After approximately
8 seconds, the protection circuit is released. Therefore, the
volumeneedsreadjustingtocontinuenormaluse.Ifexcessive
ultrabasssignalinput continuesorif DCvoltageisdetected
owingtotroublewiththeamplier,theampliershutsitself
OFF,andtheSTANDBYindicatorashes.
Todeactivatetheprotectioncircuit,turntheunitothenback
onagainafterabout1minuteormore.
About the protection circuit
If the main-amplifier overheats
Theprotectioncircuitisactivatedifthetemperatureofthemain
ampliersectionrisesaboveacertainlevel,whichcanhappen
iftheamplieriscontinuouslyusedwithexcessivesignalow
beinginputtoit.Theprotectioncircuitisalsoactivatedwhen
thespeciedoperatingtemperatureisexceeded,whichcan
happeniftheventsontopoftheamplierarecoveredorif
the amplier is installed on a cramped audio rack. In such
a case, the STANDBY indicator ashes, and the volume is
automatically reduced. After approximately 8 seconds, the
protection circuit is released. Therefore, the volume needs
readjustingtocontinuenormaluse.
If the temperature does not suciently fall within a certain
amount of time after the protection circuit activation, the
ampliershutsitselfOFF,andtheSTANDBYindicatorashes.
To deactivate the protection circuit, turn the unit o, let it
standuntilitcoolsdown,thenturnitONagain.
In the event of amplifier trouble
Theprotectioncircuitisactivated,andthepoweris
automaticallyshutOFF,ifanabnormalityisdetectedinthe
powercircuit.Thesamehappensifthemainfuseinside
theamplierblows.Insuchcases,theSTANDBYindicator
ashes.
Turntheunitothenafterseveralminutesturnitonagain.
Ifthedisplaydoes notlightup,andthe STANDBYindicator
remainsashingaftertheunitisturnedonagain,theunitmay
beinfailure.
1.PM14S1N_ENG_Final_0708.indd 24 2013/07/11 19:14:19
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios