Marantz AVR-E300 Manual de usuario descargar pdf (Pagina 24)

Release Notes: Crestron Database Release Notes

http://www.crestron.com/release_notes/crestron_database_33_05.html[8/14/2012 8:56:01 AM]

Version 19.07

Added support for MPC and MPS-250

Version 19.06

Added Generic Analog Input (analog_input_x1.cmc)

Added Generic Digital Output (dig_output_x1.cmc)

Added Photocell Sensor (photocell_analog_v1_1.cmc)

Added support for TPMC-4XG within PanelDef

Added support for DVPHD firmware version 3.001.0027

Added support for Crestron SideShow

Release D-NAV object for TPMC-8X, TPMC-8L, TPS-12, TPS-15, TPS-17, TPS-12G-QM, TPS-15G-QM,

TPS-G-TPI, TPS-GA-TPI and DVPHD Panels.

Version 19.05

Enabled Engraver view for the QMMD 4X4, and QMMD 16X16

Version 19.04

Added SIMPL Windows support for AMS-AIP

Fixed C2N-TXM used with APADs

Fixed APADs with the AAS on AADS systems

Bug fix for D3Pro caused by cresdb 19.04.07 - Unable to add Fluor. Dim Loads or open an existing

project containing such load types.

Version 19.03

Added Crestron Modules, Simpl+ and Database entries for AMS-AIP support.

Version 19.02

Update to c2n-sdc shade control module

Version 19.01

Added support for new keypads: HTT-B10X, C2NI-CB, INET-CBD, and INETI-CB

Updated modules: TSTAT w/5-2 Scheduler, THSTAT w/5-2 Scheduler, TSTATRF w/5-2 Scheduler

D3Pro database entry: Added support for startup delay of a switched non-lighting load on CLX-4HSW4

Version 19.0.8

Added MPS-300 Protected Modules.

Fixed: Crestron C2N-TXM Hardware Interface v2.0.cmc. After program upload or reset, incorrect power

state of device was possible. Added ability to detect and then power cycle in this error state.

Version 19.0.7

Added support for the C2N-CB-TS. Note: D3Pro v2.5.5 or later required. System Builder v3.03 will only

generate default keypad parameters and will ignore the settings chosen in the keypad properties menu.

Non-default values must be set manually in the generated simpl windows program.

Engraver support for the MPS-300.

Version 19.0.6

Fixed: AES front panel was including the wrong XM module.

Fixed: Engraver was causing SystemBuilder to incorrectly assign programmable hard-buttons on the

TPMC-8L.

Fixed: cnctrl2.mdb was wrongly packaged as read-only.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

Comentarios a estos manuales

Sin comentarios

Marantz AVR-E300 Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Marantz AVR-E300